Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-05-2002, 10:33 AM
|
#4 |
|
Registered Member
Join Date: Apr 1999
Location: Hayes, Va, USA
Posts: 798
|
30# injectors are good for about 430 HP in a natuarally aspirated application (using a Ford MAF), because BSFC. basically SUCKS in a blown motor this is a bit misleading. A 36# injector would be more appropriate for the same level of power. FMU's are a cheesy solution to a fuel problem in a MAF car. The best way to do it would be to get an accurate reading on HP then select an injector based on that info. Ideally if you could get then engine dyno'd with a BSFC. number, then selecting the injector would be a snap.
__________________
2002 5M GT (99% stock) 1991 5M LX (30% stock) patiently awaiting my satin silver 07 Mach 1, and don't forget the shaker |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what size injectors are these? | Dave_mustang_50 | Windsor Power | 3 | 08-23-2003 10:09 AM |
| 97cobra s trim....what size injectors? | sn95gt19 | Modular Madness | 3 | 03-06-2003 01:03 AM |
| Please Help!! I need to know what size injectors to use.. | Joe_mama71 | Windsor Power | 2 | 08-19-2002 10:09 PM |
| What size injectors for a Procharger set-up | o2superstang | Modular Madness | 1 | 07-20-2002 09:37 PM |
| what size injectors? | Chipdog | Windsor Power | 5 | 02-12-2002 11:11 PM |