Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-08-2002, 03:36 PM
|
#4 |
|
Registered Member
Join Date: Nov 2001
Location: Sunny, Hot, Sebring, Florida
Posts: 725
|
The only way to fully port a stock upper is with extrude honing or cut it in half, either way, the cost would be the same as a Cobra intake, which with long/short runners would be better than the ported stocker.
I'm not going to comment on the E7's, because i always get slammed.
__________________
Remember...2nd place is 1st place for losers! |
|
|
|
|