Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-03-2001, 02:59 PM
|
#4 |
|
Guest
Posts: n/a
|
I too did the same thing on my 306, great fit no problems I will say this the dipstick into the pan, well thats a PAIN to bend and get PERFECT.. other than that its sweet install.. I also used factory pan stiffeners
------------------ SOLD THE 87GT, .. GT40, 70mmTB, 75mmBullet, 24lbinjectors, cold air induction, Edelbrok 6025 Rpm's, Inch phonolic spacer, tall FMSvalve covers, an SFI balancer, Canton 7quart, the shortblock... Lunati 51025 (224/232 .535/. 544 @112 deg) Ross lightweight pistons (10:1) Eagle H-Beams, Total Seal plasma Moly Rings, Clevite bearings, ARP throughout, FMS main Girdle&Studs, Forged Crank, of course HV-OilPump and hardened FMS shaft, Dual Friction centerforce, T5, and 4.10's Longtubes and 2.25 tail pi |
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351 dual sump Canton pan leaking so I pulled the engine | Stang_ROTY | Windsor Power | 9 | 06-14-2003 10:59 PM |
| New Canton Oil pan leaking from drain plugs? | Stang_ROTY | Windsor Power | 5 | 08-29-2001 03:15 PM |
| D.S.S. Main support system & Canton pan??? | Stang_ROTY | Windsor Power | 1 | 05-02-2001 10:58 PM |