Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-14-2002, 03:10 PM
|
#4 |
|
Registered Member
Join Date: May 2001
Location: Yuma, AZ
Posts: 536
|
Since you're on the topic of roller conversions, I have a question. What's the difference in an HO 302 with a roller cam, and a Non-HO 302 with a flat tappet cam, other than the tapped threads for the spider. Are the slots for the lifters taller with the HO's. I didn't know of the question on the shorter lifter need was because you're doing a 351, or if that was a roller conversion question. I had a friend ask me the difference the other day, and I wasn't sure what to tell him.
Dave |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Which pushrods for a 351W roller cam? | Miguel | Windsor Power | 1 | 06-13-2002 11:41 AM |
| Non-Roller to Roller Block Conversion | Todd_A | Windsor Power | 1 | 06-01-2001 11:01 AM |
| Best Roller Cam For a 351w? NEED HELP!! | BowTie Eater 5 Liter | Windsor Power | 4 | 02-27-2001 09:36 PM |
| 351w conversion | BLOCKER | Windsor Power | 2 | 02-22-2001 08:46 AM |
| Roller Bearing Idler Arm Conversion | Dinosaw | Classic Mustangs | 0 | 06-11-2000 07:12 PM |