

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Moderator
Join Date: Sep 1998
Location: Grand Rapids, Michigan, USA
Posts: 1,001
|
![]() Thanks for the help, guys. I really appreciate it!
![]() Rick 91GT: thanks for that info! I'll be sure to email Brian about this very subject and about a good stroker kit. D&R Stang: you're right that the roller lifters are taller than their flat couterparts. That's the reason you can't just whip 5.0 rollers into a non-roller block and call it done. The short roller conversion lifters that Crane makes are the same overall length as the flat lifters, so they won't extend too far past the bore. The ramps of the cam's profile are much different as well between the two.
__________________
Capri306, Moderator The Mustang Works Online 1979 Mercury Capri 1987 5.0L Mustang LX Notchback 1993 5.8L Eddie Bauer Bronco ![]() |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Which pushrods for a 351W roller cam? | Miguel | Windsor Power | 1 | 06-13-2002 11:41 AM |
Non-Roller to Roller Block Conversion | Todd_A | Windsor Power | 1 | 06-01-2001 11:01 AM |
Best Roller Cam For a 351w? NEED HELP!! | BowTie Eater 5 Liter | Windsor Power | 4 | 02-27-2001 09:36 PM |
351w conversion | BLOCKER | Windsor Power | 2 | 02-22-2001 08:46 AM |
Roller Bearing Idler Arm Conversion | Dinosaw | Classic Mustangs | 0 | 06-11-2000 07:12 PM |