PVC air intake (no, not PCV)

Killercanary · 04-09-2001, 10:58 PM

Its been a while but I think I used 3" PVC tube, and 2 rubber connectors. For the crank vent I screwed a copper pipe fitting into the PVC and attached the hose to it via a hose clamp. For my ACT sensor I just screwed it right into the pipe. This is on my 95 though, I guess all you'd need to do is get a 90 or 45* elbow near the T-body. A conical filter has a good bit more surface area to draw from as compared to a flat panel one. I picked up 1mph and dropped one tenth with this setup. I have a picture on my site at: http://www.angelfire.com/pa2/killercanary

------------------
95 GT convt' 5 speed, 3.73's,FMS HD clutch, Pro 5.0 shifter, ASP alum. underdrive pulleys, Bassani offroad X pipe, 2 chmbr flowmasters, K&N w/o silencer, edelbrock performer intake, FRPP 65mm T-body, FRPP shorty headers, FRPP aluminum driveshaft.Hooker 4pt chrome car bar, Xenon/Wings West ground effects, custom interior
Best ET: 13.83
Best MPH: 98.55mph with Best 60': 1.91 on Nitto DR's
Homepage: <A HREF="http://www.angelfire.com/pa2/killercanary" TARGET=_blank>http://www.angelfire

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Explore intake???????????	William Bowers	Windsor Power	2	02-14-2002 10:27 PM
HELP!!! oil in intake, what to do??	bosco	Windsor Power	4	02-03-2002 05:02 PM
Edelbrock spec's and intake question??	jerryIII	Windsor Power	0	05-24-2001 12:49 PM
OIL IN INTAKE almost sure from 'pcv'	QUIN	Windsor Power	8	03-09-2001 01:58 PM
Is the true about Edelbrock heads with TFS intake?	gt93mustang	Windsor Power	14	03-06-2001 07:01 PM

04-09-2001, 10:58 PM	#1
Killercanary Registered Member Join Date: Nov 1999 Location: Altoona, PA Posts: 336	Its been a while but I think I used 3" PVC tube, and 2 rubber connectors. For the crank vent I screwed a copper pipe fitting into the PVC and attached the hose to it via a hose clamp. For my ACT sensor I just screwed it right into the pipe. This is on my 95 though, I guess all you'd need to do is get a 90 or 45* elbow near the T-body. A conical filter has a good bit more surface area to draw from as compared to a flat panel one. I picked up 1mph and dropped one tenth with this setup. I have a picture on my site at: http://www.angelfire.com/pa2/killercanary ------------------ 95 GT convt' 5 speed, 3.73's,FMS HD clutch, Pro 5.0 shifter, ASP alum. underdrive pulleys, Bassani offroad X pipe, 2 chmbr flowmasters, K&N w/o silencer, edelbrock performer intake, FRPP 65mm T-body, FRPP shorty headers, FRPP aluminum driveshaft.Hooker 4pt chrome car bar, Xenon/Wings West ground effects, custom interior Best ET: 13.83 Best MPH: 98.55mph with Best 60': 1.91 on Nitto DR's Homepage: <A HREF="http://www.angelfire.com/pa2/killercanary" TARGET=_blank>http://www.angelfire