Problems with 1.7 rockers and cobra intake install (read)

[ByrdPE]

Originally posted by Oldschoolpony:
I had a similar problem in a different engine and the valve springs were at fault. It is possible that with the extra lift from the 1.7's the springs cant keep up.

Ditto!!Do you still have the stock valve springs??If so,this is probably your problem.
Good Luck!!



------------------
FMS 373,Mac U/D Pullies,B&M shift kit,B&M Trans cooler,
KYB's,FMS 65mm T/B,Moroso cold air kit,75mm Bullet,BBK sub frame connectors,Power-slotted rotors w/performance friction pads
PST performance sway-bar kit,3G alternator,Maximum Motorsports Strut tower brace,Maximum Motorsports G-Load brace
Maximum Motorsports lower control arms,Autometer,oil,H2O,
volt MSD6AL,MSD Blaster coil,'Tiny Avenger'intake pipe