Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-04-2002, 08:35 AM
|
#3 |
|
Registered Member
Join Date: Apr 1999
Location: Miami,Fl USA
Posts: 297
|
There are two sets of holes that you can mount the tensioner on. If I mount it onthe lower ones and hammer it down like you did I get a very tight belt no slip at all but one of the bolts is right where the sepentine belt passes. It dose not touch it but I am guessing at high RPMs it dose because it has shedded the belt 3 times now. If it makes things easier I can try to get some pics.
Chip
__________________
92 GT Convertible Hooker Headers, Headman X pipe, Flow Masters, 4.10s, BBK 1.5 drop, 73mm Mass air, 65 FMS TB, FMS Aluminum radiator, T-5 swap with a Steeda shifter. And a 9 pound Blow Job |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reversing the belt tensioner | Ieatcamaros | Windsor Power | 4 | 08-19-2003 06:04 PM |
| Please help stutering problem | Just me | Windsor Power | 10 | 10-18-2002 02:37 PM |
| Powerdyne 6 to 9 pullie? | Chipdog | Windsor Power | 6 | 07-17-2001 11:03 AM |