Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-06-2002, 02:06 PM
|
#1 |
|
Registered Member
Join Date: Feb 2002
Location: Monterey, CA
Posts: 76
|
I have a 67 with a 289 and i when i had this decision about a year ago i went with the 600 cfm edelbrock. there was a big improvement in power and top end speed, just make sure you have an exhaust that can handle it and make sure that you set the idle mixture properly, mine ran way too rich in the beginning and bogged a lot off the line. good luck!
Jason
__________________
67 Coupe 289, 2 1/4'' pipes w/ Flowmasters Edelbrock 600 cfm 4bbl carb, Edelbrock Airgap intake Hooker headers, MSD Ignition system Next: new tranny, T5 or Toploader |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| to carb, or not to carb...this is my question. | black86notch | Windsor Power | 4 | 08-06-2002 08:24 PM |
| Carb Woahs | RoadWarrior | Classic Mustangs | 4 | 07-27-2002 11:06 AM |
| '65 Carb Question | Wendell Allen | Classic Mustangs | 3 | 07-13-2002 04:54 AM |
| efi to carb. /? | WADS56 | Windsor Power | 0 | 09-26-2001 12:45 AM |
| new carb..but how much cfm?? | 69PonyRider | Classic Mustangs | 4 | 09-13-2001 07:59 AM |