Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-07-2002, 10:58 AM
|
#1 |
|
Registered Member
Join Date: Sep 2001
Location: zachary, la
Posts: 73
|
i would probably research the cost of new and used ones. if the new ones are decently priced then i would definately go with them. If not i would call mustang part specialties in georgia and see if they could sell the lines seperate. just make it very clear that you don't want no lines the have cracks or leaks. but they are pretty good guys so i don't think you will have a problem. if all else fails then i would try to bend my own
__________________
GT-40X(58cc)heads, cobra upper&lower, FMS 65mm TB, 75mm Bullet, 24# injectors, 190 lph fuel pump, moroso cold air intake, BBK 1 5/8 equal length headers, flowmaster cat back, 1.7 cobra rockers, crane 2031, T5Z gear box, centerforce dual friction, mcleod bullet proof bellhousing, 3.55 gears, hurst billet shifter with over 193,000 miles. thanks to all who contributed |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5 lug conversion | stanger9219 | Windsor Power | 2 | 02-25-2004 11:31 PM |
| What all do you need to do rear disc conversion w/ SN95 Parts | KG88GT | Windsor Power | 1 | 07-29-2003 01:45 PM |
| questions about maf conversion | spankaveli | Windsor Power | 10 | 10-19-2002 02:46 PM |
| 5 to 4 lug conversion | mike_navigator | Blue Oval Lounge | 7 | 08-14-2002 11:17 PM |
| mass air 87GT conversion | greydan | Windsor Power | 3 | 01-02-2002 07:57 PM |