Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-13-2002, 03:00 PM
|
#18 |
|
Registered Member
Join Date: Feb 2002
Location: Jacksonville, FL
Posts: 706
|
Ignition...
If it helps, I just put in a new cap and rotor on my billet Mallory ignition and my MSD wires are only 2 months old. MSD Balster coil is 2 months old too. I bumped the timing all the way to 18* for a while , then back to 14* now. Calling Superchips in a minute. Good Luck. By the way, what code is on the side of your EEC-IV (i.e. A9L)?
__________________
1988 GT Convertible 331 10:1 TW heads, GT-40 intake, MSD, TRW flattops, B Cam w/ 1.7's, MAC exhaust, 24's, 70 TB, 76 MAF, 3.73's, Pro 5.0, Koni's, Anderson PMS, Wideband 02, yatta, yatta... One week with new motor, two speeding tickets...joy |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
| high rise manifold | fordkid68 | Classic Mustangs | 2 | 05-18-2003 01:38 AM |
| 306 street fighter from Coast High. short-block | yelowjaket | Windsor Power | 2 | 05-15-2003 06:02 PM |
| Fuel pressure at high altitude. etc... | Dark_5.0 | Windsor Power | 5 | 04-19-2002 07:52 AM |