Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-14-2002, 02:09 PM
|
#3 |
|
Registered Member
Join Date: Jan 2001
Location: okemos
Posts: 205
|
you need to remove the spout connector , before setting the timing. you can find it along the wire harness that is connected to the Distributor, it looks like a little plug , just pull it out set the timming (INT) and then replace after you are all said and done...
hope this helps |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Total timing vs initial timing for max HP. | Dark_5.0 | Windsor Power | 35 | 04-28-2009 11:35 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| Should I Retard My Timing??? (Quick, But Important, Please Reply Soon) | BowTie Eater 5 Liter | Windsor Power | 3 | 02-20-2002 12:51 PM |
| points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |
| timing chain or timing gear | mustang66teen | Classic Mustangs | 11 | 06-18-2001 08:44 PM |