Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-16-2001, 03:24 PM
|
#8 |
|
Registered Member
Join Date: Aug 2000
Location: santa ana ca
Posts: 1,349
|
GO BACK! Your gears definitley shouldnt make noise. They will build up too much heat and explode. They whine for a while, then it sounds like a helicopter is about to land on you car kinda like a huge WHOOMP WHOOMP sorta sound then BOOM! your whole rearend is scattered all over the freeway. Make sure its not your driveshaft making the noise though. My DS started to whine after my gear change but only because the U joints were toast. Defintitely have them checked out.
------------------ 95GT B303 cam, 1.7 rockers, 65mm TB, 73mm MAF, milled heads, 355's K&N, BBK Longtubes, Flowmaster cat back, pulleys, msd coil, 9mm wires, Tremec 3550, Pro5.0 shifter,10.5 Motorsport clutch, FMS aluminum driveshaft, weld in subframe connectors |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| raced a Supra Twin Turbo | Stang35th | Stang Stories | 63 | 08-23-2003 12:36 AM |
| The Right Speedo Gear... | Titan | Modular Madness | 8 | 09-23-2002 05:42 PM |
| Distributor gear.... is it steel? | DRASTiK | Windsor Power | 5 | 01-09-2002 12:37 AM |
| Urgent Help!!!!Just installed aluminum heads on backwards...Will it work OK??? | tb | Windsor Power | 5 | 12-31-2001 12:53 AM |
| If you've installed a 7 tooth speedo drive gear please read! | bigsnake | Windsor Power | 3 | 11-25-2001 06:51 PM |