Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-17-2001, 08:50 AM
|
#1 |
|
I'd rather be basketweaving
Join Date: Feb 2000
Location: Indianapolis
Posts: 2,551
|
your driveshaft isnt spinning any faster at all, it just accelerates faster than before, if you are at 3000RPM with 2.73s and 3000PRM with 3.73s then your driveshaft is spinning the same speed with both of them, and to answer your question, yes it is a problem and you need to have it re-done ASAP, just ask around here theres lots of guys without excessive gear whine, yours were installed improperly
------------------ 88 Notchback 5.0, 3.73's, Explorer intake, pulleys, Crane 1.7's, BBK headers, off-road H-pipe, flowmasters, subframe connectors, 65mm TB, shift kit, March ram air kit, motorsport wires, MSD coil, upper and lower control arms, 155lph fuel pump, cheap 2800 stall, Crane Adj.FPR, best time- 13.99@99.75, not yet tested times after rocker and intake install |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| raced a Supra Twin Turbo | Stang35th | Stang Stories | 63 | 08-23-2003 12:36 AM |
| The Right Speedo Gear... | Titan | Modular Madness | 8 | 09-23-2002 05:42 PM |
| Distributor gear.... is it steel? | DRASTiK | Windsor Power | 5 | 01-09-2002 12:37 AM |
| Urgent Help!!!!Just installed aluminum heads on backwards...Will it work OK??? | tb | Windsor Power | 5 | 12-31-2001 12:53 AM |
| If you've installed a 7 tooth speedo drive gear please read! | bigsnake | Windsor Power | 3 | 11-25-2001 06:51 PM |