Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-16-2001, 08:03 PM
|
#1 |
|
Registered Member
Join Date: Sep 1998
Location: Dayton, OH., United States
Posts: 467
|
I knew I was going to regret not getting that flywheel resurfaced!! I only have 60K miles on it.... It didn't look bad at all. So is this going to give my problems or cause my clutch to wear out any sooner?? If it is that big of a deal I will take it apart again just to do the flywheel??
Give me some advice here... I said a replaced the bearing retainer? No need to worry, I did use a steal one instead of the aluminum one. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clutch Questions | Rosco | Windsor Power | 27 | 04-18-2002 09:01 PM |
| Clutch pedal and steering questions... | richd | Windsor Power | 2 | 12-19-2001 10:59 AM |
| Tremec 3550, aluminum fly & clutch INSTALLED! | 302 LX Eric | Windsor Power | 3 | 10-01-2001 04:05 PM |
| SPEC stage III clutch installed.....11's here I come! | Rick 91GT | Windsor Power | 4 | 08-06-2001 10:50 AM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |