Anyone here making BIG power with pedestal mt rockers?

Rick 91GT · 04-16-2001, 03:42 PM

"Anyway, I REALLY dont want to spend another 450 or so on a shaft setup."

Do you mean STUD mount rockers most heads are made for both. You can get a set of 1.6 Crane Blazers for $200 and they are nice quality pieces, the stud mounted rockers are better for higher HP cars. Stay away from the 1.7's they add a lot of stress to the drivetrain and can cause problems with big cams, stay with the 1.6.
A Shaft mount system is nice but it will cost you $450, you could buy the stud mount 1.6's for $200 and add a set of $125 girdles if you are worried about deflection.

------------------
Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
loss of power suddenly	jimdrechsler	Windsor Power	17	09-30-2004 08:49 PM
Lost top end power	bobtodd	Windsor Power	11	08-01-2002 10:28 PM
Roller Rockers, bad?	HiFlow5 0	Windsor Power	1	04-14-2002 01:35 PM
reg rockers or roller rockers??	Chevysucks	Windsor Power	1	12-05-2001 08:17 PM
At what RPM does the 1990 302 quit making power???	Suave	Windsor Power	1	07-01-2001 08:14 PM

04-16-2001, 03:42 PM	#4
Rick 91GT Procharged! Join Date: May 1999 Location: Hanover, PA Posts: 1,539	"Anyway, I REALLY dont want to spend another 450 or so on a shaft setup." Do you mean STUD mount rockers most heads are made for both. You can get a set of 1.6 Crane Blazers for $200 and they are nice quality pieces, the stud mounted rockers are better for higher HP cars. Stay away from the 1.7's they add a lot of stress to the drivetrain and can cause problems with big cams, stay with the 1.6. A Shaft mount system is nice but it will cost you $450, you could buy the stud mount 1.6's for $200 and add a set of $125 girdles if you are worried about deflection. ------------------ Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon!