Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-19-2002, 01:49 PM
|
#1 |
|
Moderator
Join Date: Mar 2001
Location: Myrtle Beach SC
Posts: 1,643
|
I have done all of the above and it can be a headache if you have never tackled anything like it. You can do it however if your patient and use good instructions. I think you could probably buy a service manual for your car. It has a pretty detailed tear down and rebuild of and entire car. With a little common sense and by reading everything carefully you should have no problems. I am assuming that the motor is in the car. It will be a little harder doing it this way but it can be done. Be sure and read the instructions closely and follow the torque specs and you should be fine.
Brad
__________________
1990 GT, 347, TFS TW Heads, TFS Cam, TFS Track heat, Twin turbos, FMIC, T5. Built Ford Tough Moderator |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Best heads, intake, cam setup?? | project 5.0 | Windsor Power | 11 | 02-25-2003 07:48 PM |
| Heads, Intake | OneBad95 | Windsor Power | 0 | 07-22-2002 12:05 AM |
| Cobra Heads And Intake Swap | surfbeast | Modular Madness | 1 | 03-12-2002 05:41 PM |
| GT-40P heads and intake question | ex-lt1-guy | Windsor Power | 1 | 03-12-2002 09:55 AM |
| It's May, still no new heads or intake by other manufacturers? | Red Mustang Gt 46 | Modular Madness | 7 | 05-08-2001 05:22 PM |