Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
03-21-2002, 11:26 AM
|
#1 |
|
DURKA DURKA!!
Join Date: Sep 1997
Location: Lubbock, TX...(TX panhandle)
Posts: 1,418
|
Mach 1,
I've never done it, and I haven't seen more than a couple of articles briefly describing all it entails. However, I did see a technical referance manual at Hastings at one time on rebuilding AOD transmissions. It was similar to a Haynes or Chilton manual. You might look around for something like that. Also, I know that there are videos out there as well. I'll try to see if I can come up with a company. That would be the route I would take. Good luck. --nathan
__________________
'91 GT, Coast 347, 9.5:1 compression, full intake, Wolverine 1087 cam, exhaust, Keith Craft ported Windsor Jr. Irons (235 cfm intake, 195 cfm exhaust), AOD, PI 3500 converter, Lentech valve body, 3.73's (4.10's in the works), and Yokohama ES100's out back. Daily Car: '04 Infiniti G35 Sedan 6MT |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rebuild or not to rebuild??? | NotchStang59311 | Windsor Power | 9 | 04-14-2004 05:28 PM |
| T-5 Rebuild | 95/GT/5.0 | Windsor Power | 9 | 12-26-2002 10:23 PM |
| TRANS rebuild kits for 5spd | drtbiker | Windsor Power | 3 | 08-18-2002 04:25 PM |
| Low cost rebuild. | salcmc | Classic Mustangs | 3 | 09-11-2001 09:16 PM |
| advise on T-5 rebuild | 429mustang | Blue Oval Lounge | 0 | 07-23-2001 01:51 PM |