Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-17-2001, 09:44 PM
|
#3 |
|
Registered Member
Join Date: Apr 2001
Posts: 13
|
The early covers were designed to be used with a water pump that flows in the opposite direction from the late model covers that the EFI 5.0s use. They also have a hole to run a mechanical fuel pump in the side. Don not use these covers with a 5.0 engine of the motor will overheat...get the a late model cover if you can. The best place to get them is at an engine core supply. Hope this helps!
------------------ 91 coupe, SVO block 380 windsor, Brodix Neal heads, Super victor spyder intake, 90mm Accufab, 160 lb. Bosch injectors, D2-R procharger, Dynamic powerglide, 4500 stall, 9" rear, Speed Pro injection. 1047 hp at the wheels on Dynojet dyno with 23 lbs. of boost. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Total timing vs initial timing for max HP. | Dark_5.0 | Windsor Power | 35 | 04-28-2009 11:35 PM |
| Timing covers | PurposeBuilt | Windsor Power | 4 | 01-20-2003 08:32 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |
| timing chain or timing gear | mustang66teen | Classic Mustangs | 11 | 06-18-2001 08:44 PM |