Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-23-2002, 02:11 PM
|
#18 |
|
Registered Member
Join Date: Sep 2000
Location: Calgary, Alberta, Canada
Posts: 68
|
I hope that's not the case, cause we cut the old line while removing the 7.5 rear-end.
I can see how it will bolt up to the hard brake lines on the axle, but that banjo bolt really throws me off. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| tool's to install MM's braided brake lines | crazy5.0 | Windsor Power | 1 | 07-20-2002 10:43 PM |
| Stainless Steel Fuel Lines | glxstang | Windsor Power | 3 | 04-03-2002 02:30 PM |
| Disk Brake Coversion - bending brake lines | glxstang | Windsor Power | 1 | 11-03-2001 11:23 PM |
| How close is TOO CLOSE when it comes to steel braided fuel lines and exhaust??? | Stang_ROTY | Windsor Power | 1 | 07-22-2001 12:51 PM |
| SS front brake lines for M2300K | drudis | Corner Carvers Delight | 1 | 04-11-2001 12:57 PM |