Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-31-2002, 02:47 AM
|
#4 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
With a 58cc combustion chamber on stock pistons, you'll be looking at a compression ratio of about 9.75:1. With 64cc, you'll maintain the stock 8.9:1 CR.
If you ever plan on adding a power adder, I would use the 64cc chamber heads. You may have to back your timing off a little. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| Head to head | Oldschoolpony | Windsor Power | 3 | 07-01-2002 04:12 PM |
| Broke bolt in new head (Kinda Long) | 1988GTCONERTIBLE | Windsor Power | 6 | 05-12-2002 02:00 PM |
| blew a head gasket on a '93 sable | st5150 | Small Ponies | 0 | 03-21-2000 09:43 PM |