Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-01-2002, 12:25 AM
|
#14 |
|
Registered Member
Join Date: Feb 2001
Location: Stockton, Ca
Posts: 599
|
If it's the 89-93 style upper intake with that thick powder coat don't even try sanding it. First mix some strong paint removing chemicals muriatic acid might help but spray it on minutes before removing it with a pressure washer or a wire brush and a steady stream of water. Allow the mixture of various paint removers to sit over night first. After you've removed this coating the rest is easy by using a 320 grit greaseless paste or abbrasive rolls. The upper intake is a piece of cake. The lower with off set ground is tideous. Good luck
__________________
67' Fastback-Supercharged 4.6 DOHC Cobra, T-56, 8.8 more to come. 67' Coupe-EFI, AOD, 8.8 90 Gt-Supercharged,MAF,TB,1.7's ripper, bassani x, 3.55's, 01' cobras, headers. 89'GT-Supercharged,Heads,Cam,Intake,TB,MAF,power pipe,headers,offroad exhaust,black bullits. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| porting and polishing upper intake | edcpd03 | Modular Madness | 1 | 06-02-2003 04:18 PM |
| Explore intake??????????? | William Bowers | Windsor Power | 2 | 02-14-2002 10:27 PM |
| HELP!!! oil in intake, what to do?? | bosco | Windsor Power | 4 | 02-03-2002 05:02 PM |
| OIL IN INTAKE almost sure from 'pcv' | QUIN | Windsor Power | 8 | 03-09-2001 01:58 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |