Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-02-2002, 01:14 AM
|
#3 |
|
Junior Member
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
|
Either by back probing the connector, or by piercing the wires with a small safety pin, attach a DMM pos lead to the green wire, and the neg lead to the black wire. Turn key on, but do not start the engine. At closed throttle, the DMM (set to VDC 10 scale) should read below 1 vdc. Rotate the throttle to WOT, slowly, and see that the voltage increases smoothly. At WOT, it must be more than 4.5vdc. To adjust the setting, loosen the two bolts that secure the TPS, and try moving it. The optimum setting at idle is .95 vdc. If your reading is way off, and you cant move the TPS enough to get within range, remove the TPS and try elongating the holes with a rat-tail file.
Take care, -Chris
__________________
Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local
RED & WHITE! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Idle Air Adjust Spacer? | Mustvid | Windsor Power | 8 | 01-14-2004 01:35 PM |
| How to adjust my clutch | gonnagetagt | Windsor Power | 5 | 03-31-2003 10:08 PM |
| Adjust RR running or not running?? | 92Rustang | Windsor Power | 2 | 08-09-2001 04:44 PM |
| How to adjust my fuel pressure? | mustangLX92 | Windsor Power | 1 | 07-11-2001 01:16 PM |
| poor mans way to adjust stock clutch cable | 82 GT | Windsor Power | 4 | 06-15-2001 03:52 PM |