Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-02-2002, 11:23 AM
|
#7 |
|
Moderator
Join Date: Dec 1999
Location: Livonia, MI, USA
Posts: 1,194
|
I did the S&W "kit" and modified most every piece...
The kit was $150-ish then it only cost me $700 for a new MIG welder  See this link for MANY photos: http://www.dariusrudis.com/mustang/rollcage 
__________________
Darius Rudis, Moderator Corner Carvers Delight 1989 Mustang LX - Open Track Car http://www.dariusrudis.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 8-point competition engineering roll cage | Dog5ohfun | Windsor Power | 3 | 02-23-2004 01:34 AM |
| Roll cage questions | MJ86GT | Corner Carvers Delight | 1 | 11-12-2003 04:41 PM |
| Roll cage install ...a few questions | Fox Body | Racer's Club House | 2 | 07-15-2002 04:41 PM |
| Gathering info on roll cage installation. | Fox Body | Windsor Power | 5 | 02-25-2002 11:35 PM |
| roll cage install... | ed1371 | Windsor Power | 4 | 03-19-2001 11:17 AM |