MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Reload this Page Danny Bee belt drive install (pic)
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 04-02-2002, 04:13 PM   #1
PKRWUD
Junior Member
 
PKRWUD's Avatar
 
Join Date: Mar 1999
Location: Ventura, California
Posts: 8,981
Default Re: Danny Bee belt drive install (pic)
Quote:
Originally posted by ultraflo
As far as piston to valve clearance goes, when we checked it with clay I had around an 1/8'' gap; which, I believe should be plenty (PKRWUD?)...
1/8" = .125"

Your's should never be less than .080", and .100" would be even better. .125" is fine.

BTW, NICE set-up! I've always been a gear drive man, but only because I've never tried a belt drive. One day soon.

Take care,
-Chris
__________________
Webmaster:
Rice Haters Club
Jim Porter Racing
Peckerwoods Pit Stop

Support Your Local
RED & WHITE!
PKRWUD is offline   Reply With Quote
Reply

« Previous Thread | Next Thread »


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
351W belt routing Ieatcamaros Windsor Power 1 05-02-2003 08:15 PM
New Gears, Install, and Questions B2r3y Windsor Power 6 02-21-2003 05:00 PM
Hard drive install question joe4speed Blue Oval Lounge 18 01-09-2003 03:22 PM
Aeromotive Belt Drive Fuel Pumps protruck Racer's Club House 0 05-10-2002 05:31 PM
serp. belt streetfreak Windsor Power 2 10-02-2001 10:00 AM


All times are GMT -5. The time now is 01:28 PM.

Archive - Top

SEARCH