Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-02-2002, 05:13 PM
|
#8 |
|
Registered Member
Join Date: Apr 2001
Location: draper,va,us
Posts: 206
|
motorsports heads
so if you have the motorsports heads and they make the right compression ratio then they are made for the flat top 96-98 pistons right?but will the 96-98 intake fit or does the 99 up intake fit it, or do you have to get and aftermarket intake to go along with the heads? and about how much does it cost to swap with these rather than the pi heads
__________________
1998 mustang gt/manual..373s,bbk offroad h pipe,flowmaster cat back,c&l 80 mm maf,steeda triax,eibach springs,steeda ud pulleys,upr timing adjuster,screamon demos coil packs,motorsports 9mm plug wires,steea aluminum lca's,steeda heavy duty uca's and just over 100 k on the clock |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pro-M on stock motor? | NotchJohnson | Windsor Power | 3 | 03-23-2002 10:28 PM |
| What are 2001-2002 Cobras Running in the 1/4 Bone Stock? | '02 Cobra Guy | Modular Madness | 3 | 11-08-2001 01:23 AM |
| Ported Stock Heads... | FivepointOH | Windsor Power | 5 | 03-12-2001 03:47 PM |
| Would an old stock 351w have more power? | BowTie Eater 5 Liter | Windsor Power | 8 | 02-18-2001 10:54 PM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |