Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-03-2002, 02:46 PM
|
#18 |
|
NX dealer-man
Join Date: Sep 1998
Location: Peoria, Illinois
Posts: 977
|
Your hyd. rollers are can be reused on a new cam, but how many miles have you racked up on em; that would be my main concern...
If your not planning on reving past 5500-6000rpms you shouldn't have to worry about a thang! But then again, it certainly won't hurt to swap out the old ones while you're in there. One less thing you'll have to worry about! Ultimately it's up to YOU  Good Luck! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |
| Head to head | Oldschoolpony | Windsor Power | 3 | 07-01-2002 04:12 PM |
| Broke bolt in new head (Kinda Long) | 1988GTCONERTIBLE | Windsor Power | 6 | 05-12-2002 02:00 PM |
| blew a head gasket on a '93 sable | st5150 | Small Ponies | 0 | 03-21-2000 09:43 PM |