Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-04-2002, 11:54 AM
|
#3 |
|
Registered Member
Join Date: Oct 1998
Location: Suburban Chicago, Hanover Park
Posts: 695
|
Is the quadrant and firewall adjuster new and it became hard to put into gear after you put them on or were they already on and the problem happened over a period of time? The reaso I ask is because i just put in the Steeda Quadrant and a UPR firewall adjuster and I was having mucho problems getting the clutch to engage. I must have finally wiggled everything just right because when i put it back the way it was supposed to go (after trying every other combination I could think of including swapping the cable 3 times), it all came together and it works fine. I think the quadrant was at a wierd angle and wasn't moving freely (I might go back in there and put some spacers on the rod it sits on for stability). Anyway this may not be your problem, but it's easier than the one sn95gt19 had. Good luck
Chris |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| Clutch Problems | blue302 | Windsor Power | 3 | 09-10-2001 01:37 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |