Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-04-2002, 08:41 PM
|
#1 |
|
Registered Member
Join Date: Feb 2002
Location: Monterey, CA
Posts: 76
|
it depends on what you buy to a certain extent. I put a 4bbl intake and carb on my stock 67 and the hood clearance was not a problem. i'm not sure how much difference there is in hood clearance between a 66 and a 67, but i don't think it will be a problem. you can measure it if you want. take the height of the intake and carb and air cleaner, then compare it to the distance from the top of the center of the block to the hood. if you're buying a new air cleaner as well there are some cleaners that are very low profile which will give you that extra inch or two if you need it.
Jason
__________________
67 Coupe 289, 2 1/4'' pipes w/ Flowmasters Edelbrock 600 cfm 4bbl carb, Edelbrock Airgap intake Hooker headers, MSD Ignition system Next: new tranny, T5 or Toploader |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question about hoods | Jason1320 | Appearance & Detailing | 2 | 02-24-2004 12:03 PM |
| does MP Motorsports make good hoods? | 90LxDroptop | Windsor Power | 0 | 03-16-2002 05:04 PM |
| Who Has The Best Hoods? | steedamustang01 | Modular Madness | 9 | 03-11-2002 05:52 PM |
| Cheap Cowl Hoods?? | Rob23 | Windsor Power | 2 | 01-17-2002 01:59 AM |
| Cobra Auto Designs Hoods | SaleenGTS | Windsor Power | 3 | 02-14-2001 05:58 AM |