Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-05-2002, 04:25 AM
|
#6 |
|
Registered Member
Join Date: Feb 2002
Location: Concord, CA
Posts: 54
|
My mechanic fixed the seal today. He used RTV again to really seal the keyway etc., and replaced the old crankshaft seal. It didn't look particularly bad, but there was a little nicking in a couple of places...Oh well, he bought the part, and did the job for free, (he is very honest, and up front.) I can't complain. He definitely has my loyalty, and has had it for years.
__________________
__________________ '97 GT Convertible, 5-sp. K&N...Tri-ax...Steeda pullies... |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pully install problem | CaliJ1 | Modular Madness | 14 | 07-31-2003 12:34 AM |
| How hard is it to install a Steeda 180 thermostat on the 4.6 mod motor??? | 96_4.6 | Modular Madness | 6 | 12-28-2002 02:05 AM |
| h pipe install, big leak | sn95gt19 | Modular Madness | 0 | 07-21-2002 01:18 AM |
| A Question for 94-95 owners concerning 1.7RR INSTALL | SlowStang2 | Windsor Power | 6 | 09-22-2001 06:39 PM |
| new coolant leak after intake install | fiveohpatrol | Windsor Power | 15 | 03-04-2001 09:15 PM |