Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-05-2002, 09:41 PM
|
#2 |
|
Registered Member
Join Date: Feb 2002
Location: Warren, Mi.
Posts: 50
|
The Cobra and GT-40 will work on a 351 if you use the proper lower manifold from FRPP. Edelbrock makes a Victor EFI manifold kit for a 351W. I am using the Trick Flow R 351 manifold kit, it was highly recomended by Ron at Foxlake Power products. There are others out there but those are the most common I believe. You can use stock fuel rails but the hoses need to be cut off and replaced with longer pieces, due to the wider 351.
I would say check the for sale forum on this site for used parts, you may get lucky. Hope this helps a little.
__________________
91 GT Convertable, 306, TFS TW heads, B41 cam, Holley Systemax, S-Trim, Bassani LT's, and Flo's |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 351w or 347 stroker? which is better? | BLACK85GT | Windsor Power | 55 | 12-21-2002 06:52 PM |
| 351W heads on 289 stock engine | sleeperstang | Classic Mustangs | 5 | 11-21-2002 08:35 PM |
| 351W in a Fox body | greydan | Windsor Power | 4 | 07-03-2002 02:33 PM |
| 351W - engine buildup debate inside. Very LONG! | 2FastLX | Windsor Power | 17 | 11-22-2001 11:29 PM |
| EFI intakes for a 351W | 84_GT350 | Windsor Power | 3 | 10-04-2001 03:03 PM |