Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-10-2002, 07:54 AM
|
#1 |
|
or '331 LX Eric'
Join Date: Jan 1999
Location: Columbus, Ohio
Posts: 2,142
|
I just pulled my motor out this past weekend. It really wasn't that bad.
I used last weekend to "prep" everything (i.e. pulled the upper intake, disconnected all the sensors, removed the radiator, etc, etc.) We loosened the four bolts on the bell to the tranny and ended up pulling the motor out with the bell on. Worked out real well. BTW - the motor mount bolt are on pretty tight (at least mine were) - we used a breaker bar to loosen them. Good luck, E
__________________
1991 5.0 LX Coupe - 40,750 miles 331 cu. in. / Tremec 3550 / BFG Drag Radials 12.22 @ 114.31 mph - w/1.89 60' |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Built Motor? Questions | Rosco | Windsor Power | 1 | 10-22-2003 01:12 AM |
| Non-H.O Motor question(s)?........ | gtsr515 | Windsor Power | 2 | 02-01-2003 10:33 AM |
| Rebuilding an engine.. and then some | Halz | Windsor Power | 5 | 04-01-2002 02:01 AM |
| What year and type of motor do I have.. | Smokedawg | Windsor Power | 18 | 08-15-2001 05:08 PM |
| GT-40p headed motor | 89 Cobra LX | Windsor Power | 5 | 06-15-2001 06:46 PM |