Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-14-2002, 01:35 PM
|
#2 |
|
Registered Member
Join Date: Feb 2000
Location: Newnan, GA, UnitedStates
Posts: 83
|
There shouldnt be any side to side movement with the rockers torqued to spec and the lash set.I would stay with 1.6s with your set up but 1.7s wouldnt be a problem either.
__________________
92LX 5.0 Hatch,4.10 gears Auburn Pro,Mosser axels,alum drive shaft AOD hi ratio gear set,3200 stall TCI conv,Bassani long tube headers/cats,2 chamber flow masters,2.5inch exhaust,331 stroker,alum GT40 heads ported,Omega 1.7 roller rockers,JE forged pistons,Eagle rods,E cam,GT40 upper/lower intake,70mm mass,73mm Pro M bullet,MSD ignition,Cartech fuel sys w/external Aeromotive fuel pump,30lb injectors,Vortech S trim,Tubular front end,D&D coil overs up front |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Roller rockers for stock heads | QuantumMotorsports | Windsor Power | 1 | 07-14-2003 03:15 PM |
| roller rockers | bobtodd | Windsor Power | 4 | 04-07-2002 01:34 PM |
| reg rockers or roller rockers?? | Chevysucks | Windsor Power | 1 | 12-05-2001 08:17 PM |
| 1.6 roller rockers | David Fulford | Classic Mustangs | 6 | 04-22-2001 08:24 AM |
| Valve Springs & Roller Rockers | StreetStang37 | Windsor Power | 4 | 04-17-2001 03:54 AM |