Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-14-2002, 03:14 PM
|
#20 |
|
Registered Member
Join Date: Feb 2002
Location: Monterey, CA
Posts: 76
|
can anybody tell me what the size of these bolts are and what i need to torque them to? also, i need to jack up my engine in order to reattach the clutch cable, what is the safest way to do this? i'm not sure if i should take off the other two bolts before i do it, or whether thats totally necessary. any suggestions or ideas are welcome.
Thanks Jason
__________________
67 Coupe 289, 2 1/4'' pipes w/ Flowmasters Edelbrock 600 cfm 4bbl carb, Edelbrock Airgap intake Hooker headers, MSD Ignition system Next: new tranny, T5 or Toploader |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C-4 transmission | 420nitro | Windsor Power | 1 | 12-11-2003 11:10 AM |
| Transmission Identification | danmnvik | Classic Mustangs | 2 | 06-10-2003 11:38 AM |
| AOD Transmission Tech Question | jalangst | Windsor Power | 4 | 05-29-2003 05:24 PM |
| Weird Transmission Problems (Clutch) | techsan | Windsor Power | 6 | 02-06-2003 01:51 PM |