MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Windsor Power
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 04-17-2002, 11:42 AM   #1
95mustanggt
Registered Member
 
95mustanggt's Avatar
 
Join Date: May 2000
Location: Kamloops, BC
Posts: 2,875
Default

I too have had some detonation from my 95GT. I have my exhaust done from my headers back (I'm waiting until I do my heads before my headers).

My car use to detonate big time at WOT. Especially in the Texas heat. I replaced my TPS as the voltage was a little high. No change in ping.

I then changed the Coolant sensor which was also reading out of spec. As soon as I changed my coolant sensor my computer informed me that my MAF was shot. I replaced my MAF with a GMS 75mm (same as Pro-M 75mm) and the problem seemed to go away. I had my timing bumped to a full 10 degrees with my chip and when it got hot I still had some detonation. Timing is now at 9 degrees and my car runs fine.


What type and grade of fuel do use? You say you backed your timing down, what did you change it to? When I removed my chip and adjusted just my timing, I found 14 degrees would start to detonate and I limited my car to 13 degrees in the texas heat. I run 93 octane Mobil gas.

My advice to you (after you answer the above questions) is to check your computer for fault codes (If you need help let me know) and then manually check your sensors. Especially the O2 sensors as work has been done in that area.

Hope this helps, post some answers to the above questions.
__________________
1995 Mustang GT

20016 F150 Lariat Super Crew
95mustanggt is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Header and Exhaust Installation 1991GT Windsor Power 4 12-03-2002 11:17 PM
Whats the going price for long tube header installation? Dark_5.0 Modular Madness 3 09-19-2002 03:29 PM
How do I keep my header bolts in??!?!? Skyman Windsor Power 11 07-30-2002 06:01 PM
Header Gasket Help Needed Phillip Long Windsor Power 5 05-03-2002 01:59 PM
Header Gasket!!!!! swtstang Windsor Power 2 05-28-2001 10:46 PM


All times are GMT -5. The time now is 12:49 AM.


SEARCH