Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-17-2002, 04:41 PM
|
#1 |
|
Registered Member
Join Date: Jul 2000
Posts: 77
|
andy is absolutey correct. You will need to replace a couple of things bell housing drive shaft being the two biggest. I might be looking to sell my 3550 I'm trying to upgrade to a 6 speed send me a email if you are intertested. I'm not sure what price and not 100% sure if I'm going to sell it yet. I'm debating whether to sell it or not when my 331 goes in.
Email Here: triforcian@attbi.com
__________________
Stock Bottom End 302. With TFS stage II ported and milled heads. Anderson B2 cam with 1.6RR. Hooker Full Tube Headers flowing into offroad H-Pipe out Hooker mufflers. Ported Edelbrock Preformer Upper/Lower. Lots of other Goodies... Just bought a nice forged 331 stroker kit for a new block that should be ready to take 650hp of abuse. |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Which Tremec since T5 bit it? | Mad Horse | Windsor Power | 14 | 10-14-2004 09:47 PM |
| is tremec tko compatable with any bellhousing | jruppert | Windsor Power | 4 | 05-05-2003 02:23 PM |
| Tremec 3550, aluminum fly & clutch INSTALLED! | 302 LX Eric | Windsor Power | 3 | 10-01-2001 04:05 PM |
| Longtubes w a Tremec 3550? | fastang | Windsor Power | 2 | 03-15-2001 07:43 PM |
| Tremec Transmission | rtz | Windsor Power | 21 | 02-27-2001 03:02 PM |