Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-18-2002, 09:25 AM
|
#5 |
|
Registered Member
Join Date: Jul 2000
Posts: 77
|
I just noticed you went with the low compression and blower. I went with the high compression and a possible blower future. I did this because Rick Anderson loves high comp and blowers. I put my faith into that guy to tune my car from previous experience. Since you in ohio if you buy the PMS get it dyno tuned over there. I'm telling you I got lot more power out of my baby after one visit down there. It was great spanked an SS ls1 on the way back mulitple times. All the way up to 130mph. It was great.
__________________
Stock Bottom End 302. With TFS stage II ported and milled heads. Anderson B2 cam with 1.6RR. Hooker Full Tube Headers flowing into offroad H-Pipe out Hooker mufflers. Ported Edelbrock Preformer Upper/Lower. Lots of other Goodies... Just bought a nice forged 331 stroker kit for a new block that should be ready to take 650hp of abuse. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building a stroker motor | Mustang_289 | Windsor Power | 4 | 02-17-2005 12:46 PM |
| Blown Stroker Computer Help | RabidPony | Modular Madness | 10 | 02-07-2004 11:56 PM |
| 'super' stroker vs 'budget' stroker | mike5p01 | Windsor Power | 4 | 10-11-2003 10:11 PM |
| 351w or 347 stroker? which is better? | BLACK85GT | Windsor Power | 55 | 12-21-2002 06:52 PM |
| Decided to build a stroker, but where do I start? | WhiteLX | Windsor Power | 5 | 12-16-2002 10:35 AM |