Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-22-2002, 10:51 AM
|
#7 |
|
Registered Member
Join Date: Feb 2001
Location: Brooklyn originally, but Grand Rapids now
Posts: 309
|
3 inch h pipe. i need to take it to watson engeneering to have it done.
its nothing i can go and buy, its all custom. the pipe wouldnt bend over the axle so i have to go under it. it still looks sweet. the pipes come up on an angle in the center of the back of the car. the pipes are about 10 inches apart from eachother i might post pics in a month or so
__________________
Grand Valley State University Senior Accounting and Finance Major 1985 Mustang GT 19,000 ORIGINAL miles, E-303 cam, edelbrock performer RPM intake, holley 600 cfm carb, MAC headers, windage tray, 8.8 rear end with 4.10 gears, 4"cowl hood, 5lug conversion, 04 Mach1 wheels. http://www.mustangworks.com/cgi-bin/moi-display.cgi?1501 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra-R Side Exhaust -- SWEEET! | SkammyManX | Modular Madness | 3 | 04-05-2003 11:58 AM |
| Speed Secret # 4 | jim_howard_pdx | Windsor Power | 13 | 11-10-2002 03:42 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Header gaskets | Stang951 | Windsor Power | 18 | 11-01-2002 05:57 PM |
| Important Exhaust Question - Please Read | sublimelax | Small Ponies | 14 | 03-06-2001 10:14 PM |