Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-23-2002, 12:39 AM
|
#5 |
|
motors done......woohooo
Join Date: Mar 2002
Posts: 799
|
i had a question that kind of went along with his so i didnt want to post another question.... my question is basically the same except i have an e303 cam, roller rockers, edelbrock rpm heads, edelbrock rpm intake, mass air, throttlebody, cold air kit, 3.73, bored .030 over, long tubes, h pipe, 21/2 tailpipes, should i leave my timing straight up too, i have heard that advancing the cam or retarding it will make you have more low or upper rpm torque and power, i am looking for lots of low end torque. THANKS FOR YOUR INFO
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Total timing vs initial timing for max HP. | Dark_5.0 | Windsor Power | 35 | 04-28-2009 11:35 PM |
| Check engine light after steeda pullies / timing adjuster!! HELP!! | MineralGray02K | Modular Madness | 1 | 09-29-2002 01:11 AM |
| points and timing specs | xfernal | Classic Mustangs | 1 | 12-30-2001 04:20 PM |
| timing chain or timing gear | mustang66teen | Classic Mustangs | 11 | 06-18-2001 08:44 PM |
| nos & timing controller | todd5litre | Windsor Power | 5 | 01-09-2001 08:24 PM |