Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
04-30-2002, 05:38 PM
|
#1 |
|
Registered Member
Join Date: Apr 2002
Location: New Bern, NC
Posts: 18
|
Well, I just put in a Centerforce dual friction clutch (in my driveway), and I can tell you that you will need to remove the tranny to replace the t/o bearing. You can probably get by with leaving the bellhousing bolted up to the motor, but then you have to kinda fish around to get the clutch fork back onto the pivot ball. Good luck!!
__________________
'93 LX, Cobra intake, K&N conical filter, tremec, 4.10, billet quadrant and firewall adjuster, paxton fuel regulator, MAC equal length shorties, BBK X-pipe with cats, Flowmaster 2-chamber cat back with stainless tips No, I'm fat, the car is PHAT! |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Throwout Bearing Blues | Rstng93 | Blue Oval Lounge | 2 | 06-19-2004 07:41 PM |
| clutch and throwout bearing questions | bmxmon | Classic Mustangs | 0 | 05-23-2004 04:32 PM |
| T5 throwout bearing chirp..Argh | squid | Windsor Power | 1 | 09-20-2002 08:37 PM |
| bearing noise | lx5091 | Windsor Power | 2 | 09-16-2002 07:11 AM |
| Need advice on throwout bearing | RPM427 | Windsor Power | 2 | 08-28-2002 02:05 PM |