Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-01-2002, 08:03 PM
|
#3 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
That is alot of freaking wires. I was thinking of doing the same thing, nut I am in no way sure of what can be ditched and what cant be ditched.
Radon - I tried wiring the pump using different instructions and couldn't get it to work with the factory relay. I am about to rewire and try it this way. The main reason that I wanted to do it this way though was to keep the fuel pump cut-off switch. If you dont care about that you could wire it like Jeff Chambers did.
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 255lph fuel pump install | white91gt | Power Adders | 7 | 08-06-2003 11:23 AM |
| 91 bronco 302 fuel pump question | jerrys84 | Windsor Power | 1 | 10-18-2002 11:50 AM |
| Fuel Pump (dumb) question | UglyFast88 | Windsor Power | 1 | 05-20-2002 02:11 PM |
| 4cyl fuel pump ?'s | Coupe Devil | Windsor Power | 1 | 09-25-2001 04:23 PM |
| Fuel lines w/electric pump and carb | 1989_351W | Windsor Power | 1 | 07-25-2001 10:33 AM |