Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-06-2002, 05:42 PM
|
#2 |
|
Registered Member
Join Date: Sep 2000
Location: Lafayette, Indiana
Posts: 120
|
I told you in your last post that your pinion is fine it is your ring gear that needs moved. You have too much shim between the housing and the bearing on your carrier. You need to put a thinner shim between the bearing and housing to move the ring gear away from the pinion gear. You should have .006 and .012 of an inch play between your ring and pinion with the caps torqued down.
__________________
89 GT convertible, Kenny Brown level 5, Edelbrock performer, AFR 165's, Comp cams XE270HR, C&L 76, 24# inj, Crane 1.7's, 70mm BBK throttle body 298.2 hp 328.2 tq Mustang dyno "Our lady of blessed acceleration don't fail me now" Elwood Blues |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ran a fast and the fur. eclp. gst (sorry kinda long) | explicitone | Stang Stories | 6 | 06-21-2002 01:43 PM |
| Tranny blues (long) | mike5p01 | Windsor Power | 2 | 06-09-2002 12:24 PM |
| 95 Cobra - Long Tube Headers question? | Skyman | Windsor Power | 1 | 02-15-2001 10:25 PM |
| Basic gauge questions. (kinda long) | chris91LX | Windsor Power | 7 | 02-15-2001 02:42 AM |
| 1 3/4 Hooker Long Tubes vs Shorties results! | 8850 | Windsor Power | 2 | 02-04-2001 12:42 AM |