Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-07-2002, 07:56 PM
|
#9 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
Thanks for all the advice guys, but i think with the two exhausts i have now, buying another one doesn't have room in the check book right now... may after i get the heads ill get some long tubes....
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1 3/4 long tube header install. | Dark_5.0 | Windsor Power | 1 | 08-05-2004 01:51 PM |
| Headers - Shorties or Long Tube? | SleeperGT | Modular Madness | 6 | 03-07-2003 11:19 AM |
| Whats the going price for long tube header installation? | Dark_5.0 | Modular Madness | 3 | 09-19-2002 03:29 PM |
| BBK one-piece flange or MAC individual flange long tube headers. | Fox Body | Windsor Power | 10 | 04-03-2001 04:25 PM |
| 95 Cobra - Long Tube Headers question? | Skyman | Windsor Power | 1 | 02-15-2001 10:25 PM |