Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-07-2002, 08:18 PM
|
#2 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
I know thats a very common problem with mustangs... mym friends did it and mine was doing it for a while... you can get a kit to replace the grommet/neck at your local parts store. Pep boys probly carries it or any local parts dealer. I replaced mine with one from pep boys I believe and it hasn't given me any problems.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Safety Issue 64 - 70 Mustangs | Mach1 Cobra Jet | Classic Mustangs | 20 | 07-11-2005 08:06 PM |
| Pressure build up in Gas Tank | Fuglee | Windsor Power | 1 | 08-21-2003 02:22 PM |
| Gas Tank sealer | mustangdon2k | Classic Mustangs | 2 | 11-09-2002 07:40 PM |
| If you've upgraded your tank fuel lines, read this | fiveohpatrol | Windsor Power | 2 | 09-09-2002 11:05 PM |
| Fuel Tank Question | RMARIANI | Windsor Power | 3 | 10-15-2001 03:29 PM |