Pcvcvalve termination idea??

[82stang]

Good idea although.... Read on from Mr. Gasket

Mr. Gasket Crankcase Evacuation System


Built primarily for drag race applications, this system is designed to reduce pressure build-up in the engine crank-case. The results are better piston ring seal, less intake charge contamination, and reduced oil leaks, while increasing engine performance. Includes two chrome plated push-on valve cover breathers, breather grommets, check valves and 3-1/2'' long threaded tubes. Tubes must be welded into collectors.


This must be used with a oil baffle. I had installed this and found that without the baffle plates installed into the valve covers you will pull oil right into the collectors.

Check them out at Jeg's or Summit - $35 or so...