Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-11-2002, 08:03 PM
|
#3 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
Do you race it on the street at all? With the stock linkage, the rear can travel over 2 inches left to right when corning at full ability. You might broke/bent a few parts. I would jack it up and take a real good look to see if everythingis still straight back there.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| new rear end | fordkid68 | Classic Mustangs | 18 | 11-24-2009 08:05 PM |
| want rear disk without changing overall length of rear....please help!!! | dragstang86 | Windsor Power | 1 | 07-31-2003 06:32 PM |
| installing cobra rear in my LX...picked up a totaled 93 limited edition | dragstang86 | Windsor Power | 1 | 05-26-2003 11:23 AM |
| Rear Brake Line Removal | Kisner | Classic Mustangs | 2 | 03-13-2002 12:31 PM |
| Recall 01S15 Rear Knuckle replacement | folthoff | Special Production | 0 | 05-02-2001 08:28 AM |