Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-03-2001, 08:55 PM
|
#2 |
|
Registered Member
Join Date: Oct 1999
Location: Cincinnati, Ohio
Posts: 1,575
|
Yeah, it will pass. If your running stock heads it's a waste of money because the ports are so much biggger then the ones on the heads it doesn't align right and cause's turbulance. I have heard alof of misalignment storys with there intake and aftermarket heads too. I would stick with something else like the Edelbrock or new MAC.
------------------ 87 GT, 4 inch cowl hood,17x9 Cobra R's/255/45's,GT-40 heads,long tubes headers,h-pipe,Flows,BBK cold air, Mass air,70mm MAF, 1.7's, 1" spacer,underdrive pulleys,Pro 5.0, King Cobra, Adj. fuel Reg., Lakewood Lift Bars,50/50's,subframes, 4.10's. Best time 12.96 Best MPH 103.42 Best 60' 1.695 Visit my site at: http://www.geocities.com/cobrar93_2000/MyPage.html |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head and intake flow. Something to think about. :) | 5ohCOUPE | Windsor Power | 3 | 03-16-2003 08:52 AM |
| more gasket questions, intake... | Coupe50h | Windsor Power | 3 | 03-05-2003 01:37 PM |
| How do compare heads and intake. | GodStang | Windsor Power | 4 | 02-01-2003 11:37 PM |
| 4.6L Intake spacer!!!! | skz4u | Modular Madness | 18 | 01-27-2003 11:11 PM |
| Head and intake questions and ideas | bad85gt | Windsor Power | 11 | 01-08-2003 07:06 AM |