cobra intake spacer?

gray87GT · 05-03-2001, 11:37 PM

Yeah, I have the BBK 3/8" spacer that blocks off the EGR into the upper. I honestly can't tell you how it effects my car cause I installed everything in my sig at the same time. It runs pretty good, has a little surge at idle but if you rev it a little it idles down nicely. It's an 87, so I don't have a check engine light.....and I haven't scanned it yet so I don't know if it throws the light on, but I think it would. I just plugged off the vacuum lines that go to the valve, if I have any problems that I can pinpoint to the EGR I will let you guys know.

DemonGT: If you plan on getting the Cobra intake, you should get a plenum spacer since the vacuum port on the bottom of the plenum rests on my valve cover, so it would definatly hit without the spacer.

------------------
87 GT, BBK shorty's, offroad H-pipe, ASP pullies, 70mm T.B., Cobra intake, no smog pump, Windsor Jr irons, Comp cams 1.6 rollers, F303 cam, H.D. export W.P., Tri-Ax, FMS subframes, Battle boxes, SSM liftbars, FMS King Cobra clutch, mass-air conversion, 73mm C&L, 24lb injectors, BBK fuel pressure regulator, 3/8" no EGR spacer, and other piddly sh*t.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
cobra tb to intake studs	scale	Windsor Power	1	04-18-2003 11:03 AM
cobra intake	scale	Windsor Power	1	04-07-2003 11:36 PM
Cobra Intake ??	swede	Windsor Power	2	11-28-2002 06:12 PM
Cobra Intake?	95mustanggt	Windsor Power	5	10-01-2002 09:55 AM
sn95 Cobra intake vs older sn93 Cobra intake	Fordman50	Windsor Power	2	03-17-2001 01:09 AM

05-03-2001, 11:37 PM	#6
gray87GT Registered Member Join Date: Jan 2001 Location: Minnesota Posts: 177	Yeah, I have the BBK 3/8" spacer that blocks off the EGR into the upper. I honestly can't tell you how it effects my car cause I installed everything in my sig at the same time. It runs pretty good, has a little surge at idle but if you rev it a little it idles down nicely. It's an 87, so I don't have a check engine light.....and I haven't scanned it yet so I don't know if it throws the light on, but I think it would. I just plugged off the vacuum lines that go to the valve, if I have any problems that I can pinpoint to the EGR I will let you guys know. DemonGT: If you plan on getting the Cobra intake, you should get a plenum spacer since the vacuum port on the bottom of the plenum rests on my valve cover, so it would definatly hit without the spacer. ------------------ 87 GT, BBK shorty's, offroad H-pipe, ASP pullies, 70mm T.B., Cobra intake, no smog pump, Windsor Jr irons, Comp cams 1.6 rollers, F303 cam, H.D. export W.P., Tri-Ax, FMS subframes, Battle boxes, SSM liftbars, FMS King Cobra clutch, mass-air conversion, 73mm C&L, 24lb injectors, BBK fuel pressure regulator, 3/8" no EGR spacer, and other piddly sh*t.