Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-20-2002, 01:24 PM
|
#6 |
|
Registered Member
Join Date: Sep 1999
Location: sinful boys SO CAL
Posts: 736
|
the spring is no big deal it dont have barely any pressure on it. and it when putting it back on it goes right back into place. getting the bushings into the torque boxes was the *****. i had a five pound rubber sledge and beat the shiz out of it for an hour until it finally went in. just get a few buddies to come over and buy a few cases of the laughing brew and its a piece of cake.
__________________
89 GT, 3.55's, longtubes, pro chamber, flowpath dumps, mac uppers and lowers+ pinion snubber, underdrive pullies, 70mm t-body, 190 lph penis pump, mildly home ported E7'S by the kid hisself, nitto drag radials..... 13.4 @ 106......... on nitto drag raidials. spinning like gangbusters...... chevy silverado w/ a full works suzuki RM 250 and a full works honda fourtrax 250R (girlfriends bike) in the back, moto x'in it up bro! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lower control arms....what to get? | 84LX89GT | Windsor Power | 24 | 02-28-2017 06:53 PM |
| Trying to change lower control arms | PeTr0 | Windsor Power | 2 | 01-05-2003 09:02 AM |
| granatelli lower control arms are junk! | sn95gt19 | Windsor Power | 9 | 07-02-2002 09:37 AM |
| Rear lower control arms | explicitone | Windsor Power | 5 | 04-24-2002 11:49 AM |
| REAR UPPER AND LOWER CONTROL ARMS | bcinyuz | Windsor Power | 1 | 05-08-2001 04:17 AM |