Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-23-2002, 12:02 AM
|
#1 |
|
Registered Member
Join Date: Oct 1999
Location: New Mexico
Posts: 488
|
To tell you the truth, I am not sure if the sending units will be the same or not. I know one is bigger than the other, but not sure which one. I know this doesn't help much, but its been about 2 yrs since I put mine in. I know the autometer one is a different size though because I had to go buy an adaptor so that it would fit into the stock sending units port. I'd say give it a try anyway with the stock unit, with the stock wire disconnected of course, and see how that goes. Maybe even buy a new sending unit from autometer, or a local store, and see if that helps. Just trying to throw out some suggestions here. Hope they help.
Chris |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Water Temp sender | Faster & Mor Furious | Modular Madness | 0 | 08-12-2003 07:43 PM |
| Water Temp. Sending Unit Location | mimicons | Windsor Power | 4 | 05-01-2002 01:10 PM |
| water temp gauge | 302crew | Windsor Power | 3 | 03-22-2002 06:18 PM |
| Mech water temp guage | mustangLX92 | Windsor Power | 6 | 11-19-2001 11:16 AM |
| Temp Guage, going crazy, your opinions... (long) | jerryIII | Windsor Power | 4 | 08-28-2001 03:54 PM |